1. Wau spine was measured on three sections and then marked the third division.
2. Wau is tied to the wing first.
3. The wing is also bound to be tied at the spine.
4. Tie at the top and bottom pieces of the spine. Make sure the parts are well balanced in both sides.
5. Attach the end of the tail and then to link the end of the wing.
6. For the particular type of Wau months back, pieces of bamboo form a semi-circle ditaut on the wing and tail Wau. Bamboo pieces enemies diraut thinner shaped into a circle in the middle belt tied to Wau. Its size is determined by the ratio that is equivalent to the area of the head of Wau.
7. The final step is to head Wau is the binding part of the head of Wau in the wings with a distance of 2 inches from the spine.
After the frame is ready Wau, a base layer called the 'land' will be installed at Wau. The goal is to Wau durable as the main character of paper are more flexible and does not penetrate the wind. Installation involves several steps:
1. Measure the paper size.
2. Then marked with pencil and paper have exceeded two centimeters from the frame.
3. Cut the excess paper and Wau had cut in the form of 'V'.
4. Glue the paper on a frame by using starch glue.
Measuring, drawing and tear pattern
Carved drawing on the body Wau is the key element that makes Wau is a unique and special. Among the steps involved:
1. Fold the four-color paper for the wings, and fold to the tail.
2. Start painting from the chest up to the tip of one wing of the empty space to site area deer, the tail section, the pattern must be drawn with the pattern on the wing.
3.Corak be cut using a sharp knife is a typical pattern and the basic pattern of Wau.
4. Patterns will be posted on the paper color, usually gold color with glue on the back of the paper sweeping pattern. Glue should be mixed with water first to avoid wrinkles. Patterned paper is placed on a damp cloth. Colored paper is placed gently on the paper pattern and then flattened with a hot iron over a damp cloth before.
5. Cut the pattern to be torn and post again with a different colored paper to complete.
6. Paste the carvings on the ground tearing Wau had just swept the starch glue on the sides only.
Parts that are not closely packed with glue using a sweep
brush painting. For Wau decorations will be affixed on the back of Wau decorative paper to cover the defects of bamboo and bone Wau-wing cross.
Wau is different to be flown must be used
The paper does not absorb water. In addition, Wau is not posted back furnishings and sculptures torn paper has only three or four layers of Wau alone compared with ornaments that have up to eight colors.
Installing crown or fringe
Jambul or signs attached to or wrapped around the tail wing of Wau.
Guavas are usually made of paper 'crepe' cut with scissors is elongated to form a fringe.
Install trunk
Trunk using the same ingredients but fitted with a crown on the head of Wau.
Install arc
The main function of the arc is to produce sound when flown Wau. Consists of four components, namely, 'bok', leaves ibus, carbuncle and bamboo chopsticks.
1. Cut pieces of bamboo with the size of half the length of the wing Wau.
2. Faces of the pieces, cut the dried leaves ibus follow the desired sound compatibility.
3. To create a carbuncle, Chinese bamboo can be used and the two-centimeter cut and punched in the middle of the size of the arc.
4. After the three components listed, stick a bow on the head with bamboo chopsticks Wau and then tied using nylon thread.
No comments:
Post a Comment